There are currently no items in your cart.

Start Shopping

Shopping Cart (0)
Log In Shopping Cart (0)0 Search
Learn the Basics of Hydro Dipping

Learn the Basics of Hydro Dipping

Learn the Basics of Hydro Dipping

Hydrographics, commonly called hydro dipping, is a method for applying a pre-printed design on a three-dimensional surface. The printing process works on plastic, hardwood, metal, and a variety of other materials.

Although you can perform hydro dipping on almost every surface, it’s worth considering that the process is very wet. You may, for instance, damage electronics if you use this process. Despite this essential warning, almost any hard surface is a candidate for placing a unique design on it.

Is Hydro Dipping Permanent?

Hydro dipping is a durable finish similar to the paint on a car. That makes it a viable solution for work that you want to last for a long time. No matter what surface you’re working on, this method will not only be a tough finish but beautiful when completed.

Prep Things the Right Way

Prep work is the first step towards completing your hydro dipping project. It’s crucial to keep the surface clean and free of debris or any material that causes an interruption.

If you plan on hydro dipping objects, you need to use the right materials. Start with an automotive primer, then apply 1-3 coats of automotive base paint and then when that is dry, you can now dip the part. Fill up any plastic container about 75% of the way with water.

When it’s time to lay the film onto the water, you must put the proper side of the film facedown. The simplest way to do that is to use a wet thumb and finger to grab one of the film’s corners. after a few seconds let go, and you’ll find that it sticks to one of them. The side that’s holding is the one that you put facedown on the water.

After you lay the film on the water, let it sit for 1 min. and then spray the activator on the film.

Look Out for Air Bubbles

At this stage, pay careful attention to see if there are any air bubbles. Any bubble that is under the film’s surface will distort the final design. If you do find one, blow on it gently to get it to move out of the way. You may have to poke or press one if it resists. It’s smart to be a bit patient and thorough as you go through the process. That way, you’ll ensure less overall blemishes in the final product. The last few stages involve spraying activator, dipping, and rinsing.

Slowly Dip Until Things Look Fantastic

You will want to dip your object in and out of the water slowly. The design ends up on the item with ink from a PVA (Polyvinyl Alcohol) film. The water-soluble film absorbs moisture. As that happens, the ink and film both soften and the design becomes more pliable.

Depending on how things look, some people also decide to add a candy to spruce up the display. It might take trying something a few times to achieve your perfect look. Nobody is an expert the first time they try hydro dipping. With enough practice, it’s possible to make out of this world designs that get attention!